Model IXUR

Description

This model is intended for long-term luxury car parking. It is designed in such a way that in the lower position the platform is turned at an angle of 3.5 degrees in order to make it more convenient to enter. The raised platform orients the car exactly horizontally. The access bridge has a widened mouth, which helps to drive onto the platform more ergonomically. Gaskets are placed at the junction of the platform covered with the sideboards so that even small amounts of moisture do not fall on the car parked below. The springs installed in the hydraulic cylinders ensure a gentle descent of the platform and a smooth start of the lift. Safety locks, hydraulic stops, and other systems are installed directly on the platform of the lift, so when the platform is in a raised position, there are no elements below that prevent free walking.

HYDRAULIC CYLINDER SPRING AND HYDRAULIC SAFETY LOCK

The springs installed in the hydraulic cylinders ensure a gentle descent of the platform and a smooth start of the lift.

Electromagnetic shut-off valves are used as safety elements

and are installed directly on the hydraulic cylinder landing water main. Since a pair of hydraulic cylinders operating in parallel are installed to increase safety, hydraulic oil flow dividers are installed to synchronize their operation regardless of the load.

RAIL

There are no elements below ( only flat rail) that prevent free walking.

SAFETY ANTI-FALILNG LOCK

Safety locks, hydraulic stops, and other guidance and stabilization systems

are installed directly on the platform of the lift.

CONTROL BOX

The electric control unit and the hydraulic system are installed directly on the rising platform.

PLATFORM SEALING

Gaskets are placed at the junction of the platform covered with the sideboards so that even small amounts of moisture do not fall on the car parked below.

DRIVE RAMP

The drive ramp has a widened mouth, which helps to drive onto the platform more ergonomically.

SPECIFICATIONS

Electrical Required

380 or 220 VAC 50/60 Hz.

Control Power

24 VAC

Power Pack

2.2kw hydraulic power pack

Capacity

2.3t

Emergency stop button
Upper limit switch
Lifting speed -0.17m/sec
Lowering speed 0.2m/sec
Electrical security class IP55
Automatic mechanical lock in the lifted position
Hydrosystem electromagnetic safety valve

DISCLAIMER

The company Hidrotiltai performs the design of this equipment including kinetostatic, strength, stability calculations, and construction, therefore we provide CE marking ourselves. We follow relevant EU machinery directives such as EN-1570-A2 when designing. We offer production to companies that have implemented the ISO 90001 standard. Hydrobridges" does not promise, guarantee or warrant that our products comply with any state, county, federal or international mandated permit, license, code, standard, certificate or any other mandate other than EN-1570-A2.

Buyer assumes full responsibility for any state, county, federal, or international mandated permit, license, code, standard, certificate, or any other required authorization related to the installation and operation of any HIdrotiltai product. Hydrobridges shall not be liable for any taxes, fines, liens, or other charges imposed on the Buyer in connection with any special or regional structural, seismic, or any other building code and/or code, or any other state, county, federal, or international authorized permit, license, code, standard, certificate or other authority, law, rule, regulation or directive issued by any other agency, government, administration or corporations with state, county, federal or international powers.