Model PERIHEL

Description

The two-post parking lift PERIHEL lifts the car from the lower position to the upper one without changing the horizontal position. This is the simplest of the models produced by HYDROTILTAI. In this type of lift, the upper position should be used for long-term parking and the lower position for daily parking.

SAFETY ANTI-FALL LOCK

The safety lock automatically mechanically locks the lift platform in the upper position. The locks are duplicated on both sides.

HYDRAULIC CYLINDER SPRING

Springs of appropriate stiffness are installed inside the hydraulic cylinders, which ensure a smoother lifting movement and increase safety.

DRIVE RAMP

The entrance ramp is made of a 6 mm thick corrugated (cici visa) sheet. The main surface of the platform is made of 3 mm thick omega profiles.

CONTROL BOX

The control box is made of a 1.5 mm thick sheet, the inner surface is covered with sound-insulating material. The electric control unit, hydraulic station, and hydraulic equipment are installed in the box.

HYDRAULIC EQUIPMENT

Electromagnetic shut-off valves are used as safety elements

and are installed directly on the hydraulic cylinder landing water main. Since a pair of hydraulic cylinders operating in parallel are installed to increase safety, hydraulic oil flow dividers are installed to synchronize their operation regardless of the load.

ROLLAPPARAT AND RAILS

Each lift column has two rails and four rollapparat. The rails are thick-walled and the rolling surfaces are precisely milled. Rollapparat consists of a body and wheels with SKF bearings. The main rolling stock receives the main radial load, the other rolling stock performs the centering of the movement.

SPECIFICATION

SPECIFICATIONS

Electrical Required

380 or 220 VAC 50/60 Hz.

Control Power

24 VAC

Power Pack

2.2kw hydraulic power pack

Capacity

2.3t

Emergency stop button
Upper limit switch
Lifting speed -0.17m/sec
Lowering speed 0.2m/sec
Electrical security class IP55
Automatic mechanical lock in the lifted position
Hydrosystem electromagnetic safety valve

DISCLAIMER

The company Hidrotiltai performs the design of this equipment including kinetostatic, strength, stability calculations, and construction, therefore we provide CE marking ourselves. We follow relevant EU machinery directives such as EN-1570-A2 when designing. We offer production to companies that have implemented the ISO 90001 standard. Hydrobridges" does not promise, guarantee or warrant that our products comply with any state, county, federal or international mandated permit, license, code, standard, certificate or any other mandate other than EN-1570-A2.

Buyer assumes full responsibility for any state, county, federal, or international mandated permit, license, code, standard, certificate, or any other required authorization related to the installation and operation of any HIdrotiltai product. Hydrobridges shall not be liable for any taxes, fines, liens, or other charges imposed on the Buyer in connection with any special or regional structural, seismic, or any other building code and/or code, or any other state, county, federal, or international authorized permit, license, code, standard, certificate or other authority, law, rule, regulation or directive issued by any other agency, government, administration or corporations with state, county, federal or international powers.