Model VPORT 2.3

Description

This type of lift is intended for parking convertibles in the upper position. When the lift rises, the rear part of the platform is raised evenly, and in the upper position, it makes an angle of 6 degrees with the horizontal. It is convenient to get out of a car parked in a lower position.

HYDRAULIC CYLINDER SPRING

Springs of appropriate stiffness are installed inside the hydraulic cylinders, which ensure a smoother lifting movement and increase safety.

KINEMATIC JOINTS

Sliding bearings are used in all articulated joints of the lift, with lubrication points screwed in for periodic lubrication.

DRIVE RAMP

The entrance ramp is made of a 6 mm thick corrugated (cici visa) sheet. The main surface of the platform is made of 3 mm thick omega profiles.

CONTROL BOX

The control box is made of a 1.5 mm thick sheet, the inner surface is covered with sound-insulating material. The electric control unit, hydraulic station, and hydraulic equipment are installed in the box.

HYDRAULIC EQUIPMENT

Electromagnetic shut-off valves are used as safety elements

and are installed directly on the hydraulic cylinder landing water main. Since a pair of hydraulic cylinders operating in parallel are installed to increase safety, hydraulic oil flow dividers are installed to synchronize their operation regardless of the load.

ROLLAPPARAT AND RAILS

Each lift column has two rails and four rollapparat. The rails are thick-walled and the rolling surfaces are precisely milled. Rollapparat consists of a body and wheels with SKF bearings. The main rolling stock receives the main radial load, the other rolling stock performs the centering of the movement.

PRODUCT INQUIRY

SPECIFICATIONS

Electrical Required

380 or 220 VAC 50/60 Hz.

Control Power

24 VAC

Power Pack

2.2kw hydraulic power pack

Capacity

2.3t

Emergency stop button
Upper limit switch
Lifting speed -0.17m/sec
Lowering speed 0.2m/sec
Electrical security class IP55
Automatic mechanical lock in the lifted position
Hydrosystem electromagnetic safety valve

DISCLAIMER

The company Hidrotiltai performs the design of this equipment including kinetostatic, strength, stability calculations, and construction, therefore we provide CE marking ourselves. We follow relevant EU machinery directives such as EN-1570-A2 when designing. We offer production to companies that have implemented the ISO 90001 standard. Hydrobridges" does not promise, guarantee or warrant that our products comply with any state, county, federal or international mandated permit, license, code, standard, certificate or any other mandate other than EN-1570-A2.

Buyer assumes full responsibility for any state, county, federal, or international mandated permit, license, code, standard, certificate, or any other required authorization related to the installation and operation of any HIdrotiltai product. Hydrobridges shall not be liable for any taxes, fines, liens, or other charges imposed on the Buyer in connection with any special or regional structural, seismic, or any other building code and/or code, or any other state, county, federal, or international authorized permit, license, code, standard, certificate or other authority, law, rule, regulation or directive issued by any other agency, government, administration or corporations with state, county, federal or international powers.