Hydro bridges

HYDROBRIDGES

Hydrobridges - a versatile loading device used for servicing trucks (furrows). Depending on the type of vehicle being transported, hydraulic ramps of several models are used.
The most widespread is the standard hydraulic ramp model, which is used for load handling from standard trailers with a flooring height of 1200mm. Such a ramp is mounted in a specially prepared place and raised to 1200mm asphalt. There are two types of ramps: with a folding bridge and a displacement. The standard ramp height adjustment range is + 220mm -280mm, so it is only suitable for standard trailers and marine containers.
The extended platform ramp is suitable for servicing the heights of a wider range of heights. These ramps can serve marine containers, and standard and Jumbo (low-floor) trailers.
The extended ramps with lifting ramps have the widest range of height equalization (+ 220mm - 650mm) and are suitable for servicing marine container trailers up to micro-buses.
If there is space in the warehouse and there is no possibility to make a large trailer for parking on the access to the building, a hydrofoil with an overpass is used.

HYDRAULIC RAMPS WITH EXTENDED PLATFORM

MODEL HR6_2x5.85_1

The extended platform ramp is suitable for servicing the heights of a wider range of heights. These ramps can serve marine containers, standard, and Jumbo (low-floor) trailers, or if expensive, easy-to-load loads are loaded and require a smaller ramp angle than the loading regulations (8%).

Installation place preparing scheme

HYDRAULIC RAMPS WITH EXTENDED PLATFORM

MODEL HR4_1.4x4_1

This model ramp is designed to serve micro buses as it is narrowed to 1.4m wide and mounted on a 1.2m high concrete ramp. As the height of the bus floor is 0.6m, the ramp with the 4m long platinum easily aligns -0.6m with a permitted 8% slope of the stevedoring regulation.

Installation place preparing scheme

HYDROBRIDGES WITH FOLDING SUPPORT

The extended ramps with folding support have the widest range of height equalization (+ 220mm - 650mm) and are suitable for servicing marine container trailers up to micro-buses. If there is space in the warehouse and there is no possibility to make a large trailer for parking on the access to the building, a hydrofoil with an overpass is used.

Metrical scheme

Installation place preparing scheme

HYDRAULIC PLATFORM WITH ESTACADE

If there is space in the warehouse and there is no possibility to make a big drill in the access to the building and the floor level of the trailer is raised by less than 800mm in relation to the warehouse floor, a hydro bridge with a trestle is used and is ideal for this.

METRICAL SCHEME

MECHANICAL LOADING RAMPS

Mechanical loading ramps are a suitable device to form a bridge to a 7m long trailer, the height range of which does not exceed 200mm (+ 70mm, -130mm) or long trailers with gas locks "locked" during loading.

The special design of the bridge hinges is particularly strong, so the Hydrotilt has a 5-year life guarantee for this component. The mini loading ramp support capacity is 4,000 kg according to EN 1398 standard. The ramp is manually operated and the other model can be operated hydraulically. Management is very simple

There are two types of installation: an outside ramp or recessed.

MECHANICAL RAMP SPECIFICATION

Mechanical loading ramp_Installation site preparation scheme

OPERATING INSTRUCTION

DEVICE PASSPORT

Platform lifting

Instruction

Bridge lifting

Instruction

Place platform to work position

Instruction

MECHANICAL LOADING BRIDGES

The mechanical loading bridge is a 1.8m long and 480mm wide platform, which is raised to a vertical position with the help of pneumatic cylinders after loading is completed and is lowered onto the floor of the truck with the help of a foot when loading begins.